GIVI Security Key Lock Replacement 3 Lock and Key Set for Select Cases
Description
Replace the locks on your Givi Case with the Givi Replacement 3 Lock & Key Set. read more-
Brand: GIVIQuestions? Call 1-855-255-5550 or contact our sales team
Sale
- Description
- Part Numbers
- Resources
- Add a review
Description
Replacement lock set for three cases. Keyed alike. Includes keys and lock components.
Compatible only with the following Givi Cases
- Dolomiti
- Trekker Outback
- E55 Maxia 3
- Trekker 33
- Trekker 46
- Trekker 52
- V35
- V47
- V46
Note: If replacing red style Givi key lock Givi Z640R Latch Plate is required for each.
Part Numbers
Our part number: | Givi SL103 |
Manufacturer part number: | SL103 |
Resources
You may also like…
GIVI Security Key Lock Replacement 1 Lock and Key Set for Select Cases
In stock
$22.50 USD Add to cart
-
Sale
GIVI Security Key Lock Replacement 2 Lock and Key Set for Select Cases
In stock
$38.70 USD Add to cart
-
Sale
Related products
SW-MOTECH Waterproof Liner Bag for 38-Liter TraX Alu-Box Top Case
Not currently available to order
-
Closeout
GIVI Z661G Key Blank for GIVI V46 and E52 Topcases
In stock
$9.90 USD Add to cart
-
Sale
GIVI 2-Case Lock Set with 4 Matched Keys | Z227
In stock
$35.10 USD Add to cart
-
Sale
PhatS1 –
I have 3 trekker cases, bought at different times so each had its own key. This set included 3 lock sets all keyed alike, with 6 keys total. I would have given 5 stars but for the lack of directions, and I could not find anything on the web except ” it’s easy” and “make a diagram of yous before you dismantle”. Well it was relatively easy, but no one mentioned the ball bearing that would come flying out! So, here are the steps to follow:
1 – open the case and look on the inside behind the lock mechanism. You will find two Phillips head screws. Remove them and retain for reuse.
2 – on the outside, pull the whole latch mechanism down and out.
3 – put the key in the lock. (BTW when examining your new locksets, do not remove the key unless the tumbler mechanism is in its sleeve. If you do, a piece will fall out of the tumbler and you might lose it)
4 – note how the plastic piece on the end of the old tumble is situated. Take a pic or draw it
5 – TRICKY PART, when you remove the nut and plastic piece as next described, there is a spring loaded ball bearing that will pop out. Look closely and you will see it below the plastic piece. Just go slowly.
6 – use a 10 mm wrench to remove the nut and washer on the end of the old tumbler
6 – pull straight out on the plastic piece, take it off and pull out the old tumbler
7 – assembly is the reverse, the only kinda hard part is keeping the ball in place when you install the plastic piece and the washer and nut.
Upvote if this was helpful (1) Downvote if this was not helpful (0) Watch Unwatch Flag for removal
Trooper –
So glad I finally got one key to work all locks on my Givi Outback trekkers. Instructions only had Maxia case information but I figured it out for the Trekkers.
Upvote if this was helpful (0) Downvote if this was not helpful (0) Watch Unwatch Flag for removal