DENALI T3 CANsmart Wiring Harness for T3 Switchback Signals

Compatible with all GEN II DENALI CANsmart Controllers, no wire tapping or other modifications are necessary, just plug directly into the circuits of the CANsmart to send the signals from your controller to the T3 Lights.  This harness is designed to power a set of four T3 lights; two rear T3s & two front T3s, but can also be configured for an installation of just front or rear T3s as well.

• Note: When using this to power 2 sets of T3 lights, this harness will use up all 4 circuits of a CANsmart. There are a couple of workarounds to avoid this, by splicing/tapping into the OEM Turn Signal wires when feasible. View the Installation Instructions under the Resources Tab for more info on the different ways this harness can be installed.