Automotive Offroad Lighting
Motorcycle Electronics
Motorcyle Accessories
Power Management
Automotive Accessories
Outback Offroad Lighting
Electrical Connection LED Motorcycle Battery Voltage Monitor
This product is no longer available.
Description
Proclaimed as an "Innovation of the Month" by Motorcycle Consumer News and the "Smart Idiot Light" by another leading magazine editor this is the smallest and simplest monitoring device available. It's also more than a light that comes on after it's too late; it's a unique and cost effective voltage indicator. read more
-
Brand: Electrical ConnectionQuestions? Call 1-855-255-5550 or contact our sales team
Closeout
- Description
- Part Numbers
- Resources
- Add a review
Description
A 1/4″ (T1 3/4) LED displays voltage levels using colors in a stoplight style arrangement: RED – less than 11.5 volts AMBER – 11.9 to 11.5 volts and GREEN – 12 volts and up. Fuse protection wiring connector assortment and complete instructions are included. Simple 2 wire installation. Remember GREEN means GO AMBER is WARNING RED means STOP! Designed for installation on bikes with a fairing or for custom installation. Drilling a single 1/4-inch hole is required to install the flush-mount LED in any flat surface near your instrument panel.
Part Numbers
| Our part number: | EC.04101 |
| Manufacturer part number: | 4101 |
Resources
You may also like…
DENALI PowerHub2 fuse block master ground block and wiring harness.
In stock
$169.99 USD Add to cart
-
Best Seller
Single Use 0.14oz Connector Protector For Protection, Sealing, And Lubrication
Low stock
$1.50 USD Add to cart
-
Closeout
Oxford Oximiser 600 – the essential 12-volt motorcycle battery charger
Not currently available to order
-
Closeout Sale
Related products
RAM Mounts B-309-7U Combination Base
Low stock
$21.99 USD Add to cart
-
Sale
Techmount adapter for attaching devices with 1 square hole to 4 holes
In stock
$7.95 USD Add to cart
-
Closeout
1-Inch Ball Mount For M6 Mounting Points
Not currently available to order
-
Closeout
SergX –
I had a very hard time getting the LED mounted, to the point where the leads broke! I was upset with myself thinking I did something wrong!
I consulted with my coworker, who is a soldering genius, and we decided to replace the LED with a flashing red (he didn’t have the correct dual-color LED in the right size) – I lost the “green / yellow” lights but – I didn’t care… if I was having a problem, a flashing red light would get my attention better.
It wasn’t until I went to install the product with his LED that I realized the original LED was put together without care for where it was going to be mounted, it had too much heat-shrink that overlapped the LED, then each lead was also heat-shrink wrapped that made the whole LED too thick to fit into the hole/mount. Which lead to the break. My friend’s version snapped into the mount PERFECTLY, the 1st time! Like the original one SHOULD have, if there was any quality control to make sure it did so before it was shipped!
But now, it works GREAT! I think I actually like the Off if everything is OK, and Flashing Red if voltage drops 12v more than I would have the original Green/”Yellow”/Red!
I was very upset at the quality control and the fact that it caused me to break it, but thanks to my friend- I am just annoyed now at the time spent, the experience, and wasting my friend’s time to fix it.
Upvote if this was helpful (0) Downvote if this was not helpful (0) Watch Unwatch Flag for removal